![]() Turn off all electrical components, including lights, radio A/C, etc., and stop the engine before the test, tap OK to confirm. Note: The battery health test must be done before performing this test. Problems with the starting motor may be caused by the following: the lubrication system is faulty, causing the motor to start with the increase of load torque, the rotor of the starting motor sweeps the bore, resulting in the increase of self friction of starting motor. It is mainly to detect and analyze the starting motor, detect the actual starting current and starting voltage required by the starting motor, so as to judge whether the starting motor is normal or not. If floating electricity is detected, please turn on the headlamp to remove it. Note: Floating electricity indicates the virtual power left by the car when it is started. Note: For any doubt on battery type, tap the link on the bottom of the screen to learn how to identify it. Used to analyze the health status of the automobile battery, calculate the actual cold starting ability of the battery, judge the aging degree of the battery, and provide reliable analysis basis for the test and maintenance of the battery. After pairing, it can be used normally.In the pop-up Bluetooth list, select the Bluetooth name (starting with MAXBATTERYxxx) of the battery tester to be paired.First, clamp the BLACK and RED clips of the battery tester on the Negative (-) and Positive (+) terminals of the vehicle battery respectively.Due to continuing improvements, the actual product may differ slightly from the product described herein, and this User Manual is subject to change without notice. Note: Pictures illustrated here are for reference purposes only. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Increase the separation between the equipment and receiver.Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. (2)This device must accept any interference received, including interference that may cause undesired operation. ![]() (1)This device may not cause harmful interference, and Operation is subject to the following two conditions: This device complies with Part 15 of the FCC Rules. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.If you have any questions on the operation of the tool, please contact Matco customer service number: 87.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |